Recycling:

• Take the dismantled workbenches (outside workshop G2) to the recycling centre
• Take the waste electronics (in old storeroom G8) to the recycling centre
• Take your junk away [EVERYONE]

G11:

• Wipe down walls (very dusty)
• Vacuum/clean cable conduits and wooden trim
• Wipe down cable conduits
• Arrange disposal/re-homing of the desks [Al]
• Run a Cat5 cable from G1 ceiling space to G11 ceiling space
• Install wifi access point in G11 and configure with VLAN for access controller [Tim]
• Purchase electronic lock release [Al] Locks ordered 6/6/16
• Fit electronic lock release [Costa]
• Finish wiring access controller [Tim]
• Order door closer [Tim]
• Order additional shelving [Tim]
• Fit door closer
• Assemble additional shelving
• Assemble 2nd round of shelving (due Fri 17th). Bolt units together this time to try and keep it straight. [Tim]
• Acquire server rack
• Assemble final two shelf units
• Fit twin-slot shelving over sink area - postpone, see what's left after we do the new workshop
• After moving existing shelf units:
  • Fit panels above shelves to prevent items falling behind them, and to secure to the wall [Costa]
• Source a pull-handle and build a capacitive touch sensor
• Fit PIR sensor and door-closed sensor to G11 [Tim]
• Final clear-out from G8 to G11

G8:

• Measure room and create a plan in Sweet Home 3D
• Agree new layout [EVERYONE]
• Build and install fitted workbench
• Install wall-mounted tool boards
• Install wall-mounted shelves
• Build an air filtering system to capture dust (since G8 doesn't have extraction or a window)
• Build a dust extraction system to capture dust from the power tools
• Purchase and install sensitive smoke alarm(s) to warn us before we cause a building evacuation

Financial:

• Recruit more members to help us pay for the room [EVERYONE]
• Notify council of status change and apply for rates discount

• Design a test pattern for checking/calibrating the laser cutter
• Update OpenStreepMap to identify all the local takeaways
• Make some door wedges