pillardrill
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
pillardrill [2020-06-12 18:52] – MirZa | pillardrill [2021-02-22 15:33] (current) – MirZa | ||
---|---|---|---|
Line 2: | Line 2: | ||
{{: | {{: | ||
- | (If you oil the stand of the blue pillar drill with PTFE lubricant, the table becomes much easier to move up and down.) | + | Left (small pillar drill): Tull LT-16J |
+ | * Adjusting the belt tension and changing the speed is done with the big nut and bolt on the right side, which allows the motor to pivot. [[https:// | ||
+ | * [[https:// | ||
+ | |||
+ | Right (Large Blue pillar drill): Union PD2 by Boxford | ||
+ | * [[http:// | ||
+ | * If you oil the stand of the blue pillar drill with PTFE lubricant, the table becomes much easier to move up and down | ||
+ | * Blue drill has an integrated thermal overload relay which is supposed to cut out above 2 Amps when overloaded (don't try triggering it though) | ||
+ | |||
+ | [[https:// | ||
+ | |||
+ | |||
+ | Maintenance log for Tull: | ||
+ | * 22 Sept 2020 - Belts fitted, drill works | ||
+ | * 14 Sept 2020 - Motor replaced. It was slightly taller and box around the belt didn't allow it to pivot enough to tension the belts - the hole in the box for the motor was enlarged and slightly shorter belts were ordered | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
+ | * 4 Sept 2020 - Tull drill press motor started smoking after a piece of metal fell inside (speculation) when cleaning the top box | ||
+ | |||
+ | Maintenance log for Union: | ||
+ | * 28 Sept 2020 - Union drill fixed. The a coil on one of the poles of the thermal overload relay integrated into the NVR contactor melted. Fix was to replace it with the coil from the unused pole of 3 phase contactor. | ||
+ | * 13 Sept 2020 - Union drill reported broken | ||
+ | * (couple years ago, 2017?) Union pillar drill hacked to work with 230V single phase instead of 400V three phase. | ||
+ | * "Costa and I fitted it with a DC supply for the contactor' |
pillardrill.1591987921.txt.gz · Last modified: 2020-06-12 18:52 by MirZa