lasercutter_training
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| lasercutter_training [2015-06-22 14:50] – More on basic use al | lasercutter_training [2015-06-22 15:18] – tim | ||
|---|---|---|---|
| Line 12: | Line 12: | ||
| Objectives for basic use: | Objectives for basic use: | ||
| - | * awareness of laser and voltage risks, and which parts of the cutter should | + | * Awareness that the laser can cause burns and blindness, that the laser compartment must remain |
| - | * powering-up and checking that the cooling and extraction | + | * Awareness that the laser cutter contains high voltages (2kV, 240V) and that users must keep clear of the wiring in the laser compartment and control panel. |
| - | * know which materials may be cut safely | + | * Know how to power-up the cutter |
| - | * the importance | + | * Know which materials may be cut safely, that some plastics may produce chlorine or cyanide gases, |
| - | * checking | + | * Know that there is risk of fire with *any* material and that the cutter |
| - | * basic use of the software | + | * Know that the cutter works best with coolant temperature |
| + | * Basic use of the software. | ||
| * setting appropriate power/ | * setting appropriate power/ | ||
| * using the cutter' | * using the cutter' | ||
| * positioning the workpiece and setting Z (vertical) alignment | * positioning the workpiece and setting Z (vertical) alignment | ||
| + | * using the test button before cutting | ||
| Objectives for basic maintenance: | Objectives for basic maintenance: | ||
lasercutter_training.txt · Last modified: 2015-10-05 15:55 by 127.0.0.1