This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
lasercutter [2018-07-21 22:06] alfie [Safety] |
lasercutter [2019-01-15 23:46] mirza [Resources] |
||
---|---|---|---|
Line 2: | Line 2: | ||
TRAINING REQUIRED BEFORE USE. | TRAINING REQUIRED BEFORE USE. | ||
+ | |||
+ | HOURS OF USE ARE LIMITED TO **8PM-8AM** UNTIL ADDITIONAL FUME EXTRACTION HAS BEEN INSTALLED. | ||
LS3060 from [[http://www.hpclaser.co.uk/|HPC Laser]]\\ | LS3060 from [[http://www.hpclaser.co.uk/|HPC Laser]]\\ | ||
Line 7: | Line 9: | ||
Laser: 40W glass CO2 | Laser: 40W glass CO2 | ||
- | {{:small_laser_cutter.jpg?300}} | + | {{:small_laser_cutter.jpg?500}} |
See also: [[lasercutter2|Laser Cutter #2]] | See also: [[lasercutter2|Laser Cutter #2]] | ||
Line 268: | Line 270: | ||
2018-07-19: | 2018-07-19: | ||
* Mike re-calibrated the axes. Previously they were off by 1mm over 260mm in Y and 0.5mm over 180mm in X. | * Mike re-calibrated the axes. Previously they were off by 1mm over 260mm in Y and 0.5mm over 180mm in X. | ||
+ | |||
+ | 2018-08-??: | ||
+ | |||
+ | * DIY chiller failed and was replaced with old ambient cooler from big laser. Seems to be keeping up with normal cutting/engraving, but cannot deal with the heat from extended 100% cuts. | ||
===== Other Specifications (for maintenance) ===== | ===== Other Specifications (for maintenance) ===== | ||
Line 283: | Line 289: | ||
* [[http://www.repairfaq.org/sam/lasersam.htm|Sam's Laser FAQ]] | * [[http://www.repairfaq.org/sam/lasersam.htm|Sam's Laser FAQ]] | ||
* [[http://www.lbp.co.uk/pdfs/pdf_files/cleaning_co2_optics.pdf|Cleaning of CO2 laser optics]] | * [[http://www.lbp.co.uk/pdfs/pdf_files/cleaning_co2_optics.pdf|Cleaning of CO2 laser optics]] | ||
+ | * {{ :lasercut_laser_palette.zip | Zeno's LaserCut5.3 Palette for Inkscape, makes all 40 layers colours match}} | ||
{{tag>equipment}} | {{tag>equipment}} |