lasercutter
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
lasercutter [2018-06-05 18:27] – Simon | lasercutter [2019-01-15 23:46] – [Resources] mirza | ||
---|---|---|---|
Line 2: | Line 2: | ||
TRAINING REQUIRED BEFORE USE. | TRAINING REQUIRED BEFORE USE. | ||
+ | |||
+ | HOURS OF USE ARE LIMITED TO **8PM-8AM** UNTIL ADDITIONAL FUME EXTRACTION HAS BEEN INSTALLED. | ||
LS3060 from [[http:// | LS3060 from [[http:// | ||
Line 7: | Line 9: | ||
Laser: 40W glass CO2 | Laser: 40W glass CO2 | ||
- | {{: | + | {{: |
See also: [[lasercutter2|Laser Cutter #2]] | See also: [[lasercutter2|Laser Cutter #2]] | ||
Line 23: | Line 25: | ||
Engraving of some coated metals is possible, Martin has documented his experiences of [[engravingaluminium|engraving anodised aluminium]]. | Engraving of some coated metals is possible, Martin has documented his experiences of [[engravingaluminium|engraving anodised aluminium]]. | ||
+ | |||
+ | ===== Safety ===== | ||
+ | |||
+ | There is always a fire risk when using the laser. The laser should not be left unattended during a cut. | ||
+ | |||
+ | Failure to pay attention to the laser can result in this: | ||
+ | |||
+ | {{: | ||
===== Prices ===== | ===== Prices ===== | ||
Line 257: | Line 267: | ||
2018-04-28: | 2018-04-28: | ||
* Mike actually tightened the nozzle up properly, fixing reported alignment/ | * Mike actually tightened the nozzle up properly, fixing reported alignment/ | ||
+ | |||
+ | 2018-07-19: | ||
+ | * Mike re-calibrated the axes. Previously they were off by 1mm over 260mm in Y and 0.5mm over 180mm in X. | ||
+ | |||
+ | 2018-08-??: | ||
+ | |||
+ | * DIY chiller failed and was replaced with old ambient cooler from big laser. Seems to be keeping up with normal cutting/ | ||
===== Other Specifications (for maintenance) ===== | ===== Other Specifications (for maintenance) ===== | ||
Line 272: | Line 289: | ||
* [[http:// | * [[http:// | ||
* [[http:// | * [[http:// | ||
+ | * {{ : | ||
{{tag> | {{tag> |
lasercutter.txt · Last modified: 2023-12-24 13:37 by simon