Differences

This shows you the differences between two versions of the page.

--- lasercutter2 [2022-05-27 02:50] – clean up todo MirZa
+++ lasercutter2 [2023-12-24 13:36] (current) – simon
@@ Line 15: / Line 15: @@
   * [[lasercutter_tips_and_tricks|Laser cutting tips and tricks]]
   * [[lasermaterials|Laser materials price list]]
+**Save your project file on the local disk if it's complex otherwise the software will be excessively slow (because the latency of the network share slows down the compile process).**
 ===== Safety =====
@@ Line 23: / Line 25: @@
 {{:flameyboi.jpg?direct&800|}}
+===== Prices =====
+See [[lasercutter#prices]].
 ===== Recommended Settings =====
@@ Line 49: / Line 55: @@
 ^ Laminate | 1.5mm | 50 | 100 | Miron |
 | :::                | 3mm |  |  |  |
+| |||||
+^ PTFE (Teflon) | 1mm | 35 | 100 | Mike |
 | |||||
 | Card (200gsm) || 40-55 | 30 | Scott |
@@ Line 191: / Line 199: @@
   * {{ :private:lasercut53-backup-20180315.zip |}} - backup of previous owner's LaserCut53 installation
   * {{ :mpc6515hardwaremanual.pdf | MPC6515 controller manual }}
+  * [[https://bristol.hackspace.org.uk/wiki/doku.php?id=equipment:a0_laser_cutter:prep|Bristol Hackspace's guide to LaserCut 5.3]]
 ===== Access Control =====