Differences

This shows you the differences between two versions of the page.

--- lasercutter2 [2019-03-20 22:05] – [Guide for existing laser cutter users] alfie
+++ lasercutter2 [2019-05-14 11:31] – [Recommended Settings] mirza
@@ Line 21: / Line 21: @@
 {{:flameyboi.jpg?direct&800|}}
+===== Recommended Settings =====
+Please add your own preferred settings here, but do not edit the existing entries. If you believe a setting is inappropriate, use strikeout and add a new entry with your corrections. Add your name to the notes so that other users can make an informed decision where there is a conflict of recommendations.
+The test were done in the centre of the cutting bed.
+^ Material ^ Cut Speed ^ Cut Power ^ Notes ^
+| Acrylic 1mm | 30 | 40 | Miron |
+| Acrylic 2mm | 28 | 100 | Miron |
+| Acrylic 3mm | 18 | 100 | Miron |
+| Acrylic 4mm | 15 | 100 | Miron |
+| Acrylic 5mm | 12 | 100 | Miron |
+| Acrylic 8mm |  |  |  |
+| Acrylic 10mm | 3 | 100 | Miron |
+| Ply 3mm | <del>30</del> 25 | 100 | Miron |
+| Ply 4mm | 20 | 100 | Miron |
+| Ply 6mm | 9 | 100 | Miron |
+| MDF 2mm | 30 | 100 | Miron |
+| MDF 3mm | 22 | 100 | Miron |
+| MDF 4mm | 16 | 100 | Miron |
+| MDF 6mm | 10 | 100 | Miron |
+| Paper |  |  |  |
+| Card |  |  |  |
+| Engraving Laminate 1.5mm | 50 | 100 | Miron |
+| Engraving Laminate 3mm |  |  |  |
+^ Material ^ Engrave Speed ^ (Range of) Engrave Power ^ Notes ^
+| Acrylic |  |  |  |
+| Ply |  |  |  |
+| MDF |  |  |  |
+| Laminate |  |  |  |
+Minimum power setting for the laser to turn on: 19
 ===== To Do =====
@@ Line 184: / Line 217: @@
 -09-22:
-  * Tube #2 (from Smoke and Mirrors) installed. All mirrors realigned to a reasonable (but not perfect) standard.
+  * Tube #2 (from Smoke and Mirrors) installed. All mirrors realigned to a reasonable (but not perfect) standard. Power level set to 33%.
 ===== Other Specifications (for maintenance) =====