lasercutter2
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
lasercutter2 [2018-09-22 21:43] – tim | lasercutter2 [2019-03-20 22:05] – [Guide for existing laser cutter users] alfie | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Laser Cutter #2 ====== | ====== Laser Cutter #2 ====== | ||
- | NOT YET IN SERVICE. | + | TRAINING REQUIRED BEFORE USE.\\ |
- | (Note: | + | (Note: |
+ | |||
+ | HOURS OF USE ARE LIMITED TO **8PM-8AM** UNTIL ADDITIONAL FUME EXTRACTION HAS BEEN INSTALLED. | ||
Model JD90125\\ | Model JD90125\\ | ||
Line 78: | Line 80: | ||
* The air assist is adjustable. Always make sure that it's enabled (on the top control panel) and that the valve (on the right hand side) is open. It's okay to reduce the air assist for delicate materials like paper, but there should always be **some** air flow enabled to protect the lens. | * The air assist is adjustable. Always make sure that it's enabled (on the top control panel) and that the valve (on the right hand side) is open. It's okay to reduce the air assist for delicate materials like paper, but there should always be **some** air flow enabled to protect the lens. | ||
* < | * < | ||
- | * The window is **tinted as all hell**. This should absorb the infra-red laser, and also absorbs literally all other light in the laser. | + | * The window is **tinted as all hell**. This should absorb the infra-red laser and most of the light from the laser. |
===== Checklists ===== | ===== Checklists ===== | ||
lasercutter2.txt · Last modified: 2023-12-24 13:36 by simon