Differences

This shows you the differences between two versions of the page.

--- lasercutter2 [2018-07-21 22:06] – [Safety] alfie
+++ lasercutter2 [2018-11-21 20:51] – tim
@@ Line 1: / Line 1: @@
 ====== Laser Cutter #2 ======
-NOT YET IN SERVICE. TRAINING REQUIRED BEFORE USE.\\
+TRAINING REQUIRED BEFORE USE.\\
-(Note: access is enabled for people who are preparing the cutter for general use)
+(Note: Access control is ad-hoc, Ask someone to add you after you have received a walkthrough.)
+HOURS OF USE ARE LIMITED TO **8PM-8AM** UNTIL ADDITIONAL FUME EXTRACTION HAS BEEN INSTALLED.
 Model JD90125\\
@@ Line 180: / Line 182: @@
 -07-19:
   * The bed level was checked and it's within 1mm all over. The axes were checked and they're within ~0.2mm over ~200mm.
+-09-22:
+  * Tube #2 (from Smoke and Mirrors) installed. All mirrors realigned to a reasonable (but not perfect) standard.
 ===== Other Specifications (for maintenance) =====
 Water tubing: silicone, 12mm OD, 8mm ID, 2mm wall\\
-Chiller: CW-3000\\
+Chiller: CW-5200\\
 Air assist compressor: Hailea ACO-328\\
 Air assist tubing: silicone, 12mm OD, 8mm ID, 2mm wall\\
@@ Line 196: / Line 201: @@
   * {{ :jd90125.pdf | JD90125 manual }}
   * {{ :lasercut5.3-software_manual-v1.6.pdf | LaserCut 5.3 manual }}
-  * {{ :cw-3000.pdf | CW-3000 Chiller Manual }} ({{ :cw-3000-2.pdf | alternative version }})
+  * {{ :cw-5000_5200_industrial_chiller_user_manual.pdf | CW-5200 Chiller Manual }}
+  * {{ :cw-5000_5200_industrial_chiller_maintenance_manual.pdf | CW-5200 Maintenance Manual }}
   * {{ :reci_dy10_dy13_dy20.pdf | Reci DY20 manual }}
   * {{ :private:20130508-lasercutter-service-report.pdf |Laser cutter service report 2013-05-08}}