heat_exchanger
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| heat_exchanger [2023-03-26 10:58] – river | heat_exchanger [2023-10-13 21:59] (current) – river | ||
|---|---|---|---|
| Line 8: | Line 8: | ||
| If there was no pressure difference on each side, a controller would not be needed. It is there to compensate for wind, or use of the extractor fan, for example. When operating, fans will be at full power in at least one direction. | If there was no pressure difference on each side, a controller would not be needed. It is there to compensate for wind, or use of the extractor fan, for example. When operating, fans will be at full power in at least one direction. | ||
| + | |||
| + | The fans may switch off if CO2 levels are low. | ||
| ===== Monitoring ===== | ===== Monitoring ===== | ||
| Line 15: | Line 17: | ||
| ===== Control ===== | ===== Control ===== | ||
| - | Someone disconnected the regulator because they didn't like the variable fan noise. | + | There may be an unstable |
| - | Regulation can now be disabled by mqtt: | + | |
| - | environment/g1/ | + | http:// |
| - | Please put it back on afterwards. | + | Please put it back to automatic when finished with any manual settings. |
heat_exchanger.1679828339.txt.gz · Last modified: 2023-03-26 10:58 by river