g14_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
g14_setup [2019-08-09 18:59] – [Tasks] tim | g14_setup [2022-05-31 12:54] (current) – removed MirZa | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== G14 Setup ====== | ||
- | |||
- | ===== Tasks ===== | ||
- | |||
- | These tasks can be started now: | ||
- | |||
- | * Install shelf for PCB etch tank | ||
- | * Deep shelf for PSU and function generator | ||
- | * Shelves (see below) | ||
- | * Order/ | ||
- | * Run 4 cat5 cables from G11 rack to G14 roof space | ||
- | * Sort/ | ||
- | * Clean ESD mats and trim to match worktops | ||
- | * < | ||
- | * Steal the worktop that currently covers the 2nd sink in G1. Cut it to make a 150x55cm shelf. | ||
- | * Obtain some chairs (3-4, computer operator chairs or " | ||
- | |||
- | ===== Shelves ===== | ||
- | |||
- | The vertical brackets are installed but we will need to order more horizontals, | ||
- | |||
- | On the narrow end of the room, above the component drawers: | ||
- | |||
- | * 3 of 226cm x 30-31cm (slightly less than 226 to allow for the conduit). | ||
- | |||
- | To the left of the window: | ||
- | |||
- | * 150cm x 54cm (for the function generator and HP power supply) | ||
- | * 150cm x 25-30cm (for oscilloscope, | ||
- | |||
- | On the long wall: | ||
- | |||
- | * Many of ~290cm x 30cm (general storage) | ||
- | * ~290cm x 25-30cm (for oscilloscope, | ||
- | |||
- | To the right of the sink, attached to wall and sink unit: | ||
- | |||
- | * Recessed shelf for PCB etch tank. | ||
g14_setup.1565377171.txt.gz · Last modified: 2019-08-09 18:59 by tim