User Tools

Site Tools


denfordnovamill

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
denfordnovamill [2018-01-11 12:07]
tkerby
denfordnovamill [2018-01-25 12:16]
mike
Line 1: Line 1:
 ====== Denford Novamill ====== ====== Denford Novamill ======
 +
 +===== Status =====
 +
 +Working. (last update 2018-01-25)
 +
 +This tool requires training before use. Training sessions are being advertised regularly on the mailing list. Contact [[people:​mikewalters]] if one hasn't happened in a while. ​
 +
 +===== Manual =====
  
 {{ :​novamill.pdf |}} {{ :​novamill.pdf |}}
  
-===Training Courses for Schools (Denford)===+=== Training Courses for Schools (Denford) ===
  
 {{ :​milling_courseware_introductory.pdf |Introduction}} {{ :​milling_courseware_introductory.pdf |Introduction}}
  
 {{ :​milling_courseware_intermediate_keystage_4_-_gnvq.pdf |Intermediate}} {{ :​milling_courseware_intermediate_keystage_4_-_gnvq.pdf |Intermediate}}
- 
-===CNC Use Notes (incomplete)=== 
-[email protected] The CNC machine== 
-  * Open VR Milling v5 
-  * (If you are introducing a new tool) New tool-> Post Processor -> Number = The variable you have used at the post-processing stage of the Fusion 360. Enter a small description of the tool 
-  * Turn red switch to turn on the machine (It is below the desk) 
-  * (For wood) Use special vice.  
-    * Select vice rouch selection of clamping. ​ 
-    * Attach vice fasteners on bed and vice. The connecting material ideally should be parallel with the earth maybe slightly higher on the screw side 
-    * Then press vice grip of wood with the screws 
-  * Home - xyz -> Jog (to the the offset 
-    * Arrow keys allow you to move around the endmill position 
-    * Set override to 100% with knobs. 
-  * Down left -> Set offsets -> Tooling ?? -> Set tool 
-    * For one tool don’t set diameter etc. This is not the case if you have multiple endmills 
-    * Click change tool 
-    * Attach the holder to the machine: 
-      * Remove the cap 
-      * Unscrew screw 
-      * The fastener should go at the middle of the opening 
-      * Clean holder& slot before attaching it 
-  * Work offsets (Find ‘0’ point) 
-    * For low precision you need to start the spindle and jog it as soon as it is cutting 
-    * Control panel -> Job -> Set spindle speed -> Hit play 
-    * Tool & offset -> Set X or Y 
-    * Add half the diameter of the tool 
-    * Check the value @ the control panel 
-    * For z do the same 
-  * File -> Open -> Select the fnc file 
-  * Control - Auto 
-  * Close water pump so that only air comes out 
- 
denfordnovamill.txt · Last modified: 2019-01-20 15:05 by mike