This is an old revision of the document!
We have a NextEngine 3D Scanner SD. Status: broken
Download the Desktop 3D scanner drivers from support.nextengine.com and go to the download section and install. (local mirror: usb_driver_installer.exe
After save is complete, right click in installer and go to Properties
Then click on the Compatibility tab and check 'Run this program in compatibility mode for:“ and set it to Windows XP SP3 and press OK
Now right click on the installer and select 'Run as administrator'
Proceed to install and make sure that the 3D Scanner driver box is unchecked (if it is checked, then proceed and just ignore the errors that might pop up)
ScanStudio will start with errors, but just close the software after it loads up
Copy the attached DLL (wdapi901.dll
) to the following directories:
Run ScanStudio and plug in scanner
If installing on a 32-bit PC, please skip steps 7-9