3dprinters
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
3dprinters [2019-04-28 16:35] – [3D Printers] DavidW | 3dprinters [2024-02-06 19:25] (current) – Prusa mini is on holiday, updated page to reflect change jaso55555 | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== 3D Printers ====== | ====== 3D Printers ====== | ||
- | === Original Prusa i3 MK 3 === | + | ===== Costs ===== |
- | [[Prusa i3 MK 3]]\\ | + | |
- | Ownership: Miron Zadora\\ | + | |
- | Status: Fully working.\\ | + | |
- | Location: G11\\ | + | |
- | Filament: 1.75 mm | + | |
- | === Original Prusa i3 MK 2 (Currently not in lab)=== | + | ^Material^Members/ |
- | [[Prusa i3 MK 2]]\\ | + | |1.75mm PLA|£0.30/ |
- | Ownership: David Weis\\ | + | |3.00/2.85mm PLA|£0.50/ |
- | Status: Fully working.\\ | + | |
- | Location: G11\\ | + | |
- | Filament: 1.75 mm | + | |
- | === Ultimaker 2 === | + | ===== Working Printers ===== |
- | [[ultimaker2|Ultimaker 2]]\\ | + | |
- | Ownership: Hacklab. Bought December 2014.\\ | + | |
- | Filament: 3.00/ | + | |
+ | |{{: | ||
+ | |{{: | ||
+ | |{{: | ||
- | ====== Approved filaments ====== | ||
- | Be careful as our printers use different diameter filament! | + | ===== Hibernating Printers ===== |
- | Most of these can be bought on amazon.\\ | ||
- | You can also try asking on the mailing list as some members may be willing to sell some of their own. | ||
- | ==== PLA ==== | + | === Ultimaker 2 === |
- | * [[https:// | + | |
- | * [[https:// | + | |
- | * [[https:// | + | |
- | * [[https:// | + | |
- | * [[https:// | + | |
- | ==== PETG ==== | + | |{{:ultimaker2_large.jpeg? |
- | * [[https://rigid.ink/|Rigidink]] | + | |
- | | + | |
- | ====== | + | |
+ | |||
+ | |||
+ | |||
+ | ====== | ||
=== 3D RepRap === | === 3D RepRap === | ||
Line 56: | Line 42: | ||
Ownership: unclear\\ | Ownership: unclear\\ | ||
Work in progress. Needs firmware reloaded and motor connectors put onto the cables. | Work in progress. Needs firmware reloaded and motor connectors put onto the cables. | ||
+ | |||
+ | |||
3dprinters.1556469354.txt.gz · Last modified: 2019-04-28 16:35 by DavidW