Differences

This shows you the differences between two versions of the page.

--- voron_2_4_r2 [2024-01-18 16:20] – jaso55555
+++ voron_2_4_r2 [2024-04-24 17:39] (current) – jaso55555
@@ Line 29: / Line 29: @@
   * [[https://www.esun3d.com/|eSun]]
-    * ABS+ is recommended, prints easier than other brands, and has a nice matte finish
+    * ABS+ is recommended, prints easier than other brands/types, and has a nice matte finish
 Please open the window and dangle the exhaust pipe outside for the duration of your print.
 ==== TPU/TPE ====
+  * [[https://www.esun3d.com/|eSun]]
 Please use the alternate bed kept to the left of the printer, although this bed cannot be run above 60 degrees or the PET coating will be damaged.
@@ Line 74: / Line 75: @@
   * PrusaSlicer (Minimum supported version is 2.6.0)
-  * SuperSlicer (Note recent versions have been buggy)
+  * SuperSlicer (Depricated)
 ==== PrusaSlicer: ====
@@ Line 83: / Line 84: @@
 To import the presets use: "File -> Import -> Config Bundle"
-==== Super Slicer (OLD) ====
+==== Super Slicer (Depricated) ====
 [[https://github.com/supermerill/SuperSlicer|SuperSlicer]]
@@ Line 137: / Line 138: @@
   * Unscrew the nozzle gently and screw in the new one.
-  * Next go into the web interface and go to **Sidebar > Config > printer.conf**
+  * Next go into the web interface and go to **Sidebar > Config > toolhead.conf**
   * At the top please comment/uncomment the correct extruder
 For example if you want the 0.25mm extruder, it should look like this: