3dprinters
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
3dprinters [2023-06-08 11:38] – simon | 3dprinters [2024-02-06 19:25] (current) – Prusa mini is on holiday, updated page to reflect change jaso55555 | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== 3D Printers ====== | ====== 3D Printers ====== | ||
- | === Costs === | + | ===== Costs ===== |
^Material^Members/ | ^Material^Members/ | ||
Line 7: | Line 7: | ||
|3.00/ | |3.00/ | ||
- | === Original Prusa i3 MK3s === | + | ===== Working Printers ===== |
- | < | + | |
- | Ownership: Miron Zadora\\ | + | |
- | Status: Gone.\\ | + | |
- | Location: Not here\\ | + | |
- | Filament: 1.75 mm | + | |
- | === Original Prusa Mini === | + | |{{: |
- | [[prusa_mini|Prusa Mini]]\\ | + | |{{: |
- | Ownership: TBD\\ | + | |{{: |
- | Location: | + | |
- | Filament: | + | |
- | === Ultimaker 2 === | ||
- | [[ultimaker2|Ultimaker 2]]\\ | ||
- | Ownership: Hacklab. Bought December 2014.\\ | ||
- | Filament: 3.00/ | ||
- | === Voron 2.4r2 === | + | ===== Hibernating Printers ===== |
- | [[voron_2_4_r2|Voron 2.4 r2]]\\ | + | |
- | Ownership: Jacob Lewis\\ | + | |
- | Status: Being tuned, but works, message Jacob on Discord for help using\\ | + | |
- | Location: G14\\ | + | |
- | Filament: 1.75 mm\\ | + | |
- | ====== Approved filaments ====== | ||
- | Be careful as our printers use different diameter filament! | + | === Ultimaker 2 === |
- | Most of these can be bought on amazon.\\ | + | |{{: |
- | You can also try asking on the mailing list as some members may be willing to sell some of their own. | + | |
- | ==== PLA ==== | ||
- | * [[https:// | ||
- | * [[https:// | ||
- | * [[https:// | ||
- | * [[https:// | ||
- | * [[https:// | ||
- | ==== PETG ==== | ||
- | * [[https:// | ||
- | * [[https:// | ||
- | ====== | + | |
+ | |||
+ | ====== | ||
=== 3D RepRap === | === 3D RepRap === | ||
Line 67: | Line 42: | ||
Ownership: unclear\\ | Ownership: unclear\\ | ||
Work in progress. Needs firmware reloaded and motor connectors put onto the cables. | Work in progress. Needs firmware reloaded and motor connectors put onto the cables. | ||
+ | |||
+ | |||
3dprinters.1686224333.txt.gz · Last modified: 2023-06-08 11:38 by simon